Experimental study on material flow in cold rolling.

Material flow in roll bite occurred during symmetric or asymmetric rolling of thin sheet was investigated by model rolling experiment in this study. The sheet samples with fine grids drawn by laser processing on longitudinal-thickness cross-section at the middle of the sheet width were used for the experiment to visualize material flow. By measuring the changes of roughness in the cross section after rolling, it was confirmed that the rolling was conducted practically in plane strain conditions in the cross section. Also the changes of vertical ruled lines before and after rolling reflect material flow throughout the roll bite. It clearly shows the characteristic that the inclination angle of the ruled line due to rolling increases monotonically as the different speed ratio increases. To compare the material flow of model rolling experiment, two dimensional steady-state rolling analyses using rigid plastic finite element (FE) method have been conducted. The profiles of the ruled line observed in the experiments have a good agreement with the calculated results. Also the calculated results of equivalent plastic strain reveal non-monotonical relations between the strain and the different speed ratio (i.e. maximal of the strain observed at certain different speed ratio). This qualitative discrepancy observed between the measured angles and the calculated strains in relation to the different speed ratio suggests that measurement of the angle of the ruled lines is not sufficient to characterize plastic strain. [ABSTRACT FROM AUTHOR]

Copyright of Procedia Engineering is the property of Elsevier B.V. and its content may not be copied or emailed to multiple sites or posted to a listserv without the copyright holder's express written permission. However, users may print, download, or email articles for individual use. This abstract may be abridged. No warranty is given about the accuracy of the copy. Users should refer to the original published version of the material for the full abstract. (Copyright applies to all Abstracts.)